What To Do If - Progress PAS6000E Notice D'utilisation

Type of dirt
fat splashes
shiny metallic discolor-
ation
* Scrapers and cleaners for glass ceramic
and stainless steel can be purchased in spe-
cialist shops
Remove stubborn residues with a clean-
er for glass ceramic or stainless steel.

What to do if ...

Problem
The cooking zones will not
switch on or are not functioning
The residual heat indicator is not
displaying anything
The appliance switches itself on
and then off again.
is lit
and number are displayed
If you are unable to remedy the problem
by following the above suggestions,
please contact your dealer or the Cus-
tomer Care Department.
immediately when the appliance
---
---
Possible cause
More than 10 seconds have
passed since the appliance was
switched on
The child safety device is switch-
ed on
Several sensor fields were
touched at the same time
Automatic switch off has been
triggered
The cooking zone was only on
for a short time and is therefore
not hot
The On/Off sensor field has
been covered up, e.g. by a cloth
Overheating protection for the
cooking zone has been trig-
gered
Automatic switch off has been
triggered
Electronics fault
Remove
has cooled down
yes
yes
Scratches or dark stains on the glass
ceramic that cannot be removed do not
however affect the functioning of the ap-
pliance.
Switch the appliance on again.
Deactivate child safety device
(See the section "Child safety
device")
Only touch one sensor field
Remove any objects (pan,
cloths, etc.) that are lying on the
control panel. Switch the appli-
ance on again
If the cooking zone is supposed
to be hot, call the Customer
Service Department.
Do not place any objects on the
control panel
Switch off the cooking zone.
Switch the cooking zone on
again
Switch off the cooking zone.
Switch the cooking zone on
again
Disconnect the appliance from
the electrical supply for a few mi-
nutes (Take the fuse out of the
house's wiring system) If after
switching on again,
played again, call the customer
service department
Warning! Repairs to the appliance are
only to be carried out by qualified service
engineers. Considerable danger to the
user may result from improper repairs.
progress 19
using
cleaner for glass ceramic
or stainless steel *
cleaner for glass ceramic
or stainless steel *
Remedy
is dis-