Troubleshooting; Before Calling For Service Checklist; Thermal Cut-Out Switch For Control Box Components - Lincoln Impinger 3200 Serie Manuel D'entretien & Manuel D'installation

Before Calling for Service Checklist

Problem
Doesn't operate
Uneven heating
Over or under cooked
Heat and cooking odors spill into room
Conveyor does not operate
Thermal Cut-Out Switch for Control Box
Components
These ovens include a "safety thermal cut-out switch" for
your protection. This safety related device is designed to
ensure that the unit will not overheat and damage the
oven. In the unlikely event that the oven would exceed the
specified operating temperature range, the "safety thermal
cut-out switch" will activate, thus blocking power to the unit
and causing it to turn off.
Part Number 11020000487 Rev A (2/16)
Section 5

Troubleshooting

Cause
Breaker tripped
Safety thermal cut-out trips
No gas
Fingers incorrectly assembled
Fingers in wrong location
Incorrect temperature setting
Incorrect conveyor speed
Temperature control out of calibration
Ventilation/exhaust hood is off
Ventilation/exhaust filters require cleaning
Defective ventilation/exhaust system
Incorrectly installed
Drive sprocket is loose
Drive chain loose or disconnected
Conveyor has stretched from use
Correction
Reset breaker
Reset power, call for service if it repeats
Check gas valve is "ON" and gas hose
connection is properly attached.
Reassemble correctly
Place fingers in correct location
Adjust temperature
Adjust conveyor speed
Call for service
Energize the ventilation system
Clean all filters
Call for service
Remove and reinstall
Tighten drive sprocket
Verify installation is correct - Call for service
Call for service
29