Stand And Finger Assembly - Lincoln Impinger 3200 Serie Manuel D'entretien & Manuel D'installation

Section 2
Stand Assemblies
1. For Single Stack Ovens: The stand is a 50" (1270 mm)
x 40" (1016 mm) rectangle. Set it in place with a 50" side
facing out. This will be the front of the oven. To raise or lower
the stand, use the leg adjusters. Ovens on casters require a
level floor. NOTE: The oven top is packed with oven stand.
Remove top from stand before assembly
PN/4001
2. Oven Placement: Remove the oven from the dolly and
set it on the stand. The control panel should be on the right
rear as you face the oven. Be sure that the oven sets squarely
on the stand and is fully seated. For a single oven, install top.
n
Verify the four brackets are fully assembled to the door.
The door must be fully assembled, as shown, to avoid
injury during installation and operation.

Stand and Finger Assembly

Part Number 11020000487 Rev A (2/16)
Warning
Installation
17