Lincoln Impinger 3200 Serie Manuel D'entretien & Manuel D'installation page 20

Installation
Finger Assemblies
6. Verify that the top retaining
bracket, with the "T" mark is
on the top, and the "B" mark
is on the bottom retaining
bracket.
7. Before installing the
retaining brackets in the
oven(s), be sure all of the
packing material is removed
from the plenum shroud.
Install the finger retaining
brackets by placing them
upside down and hooking
the retaining pin as shown.
(See Figure 1.)
8. Rotate the finger brackets
until the notches in the
brackets sit on the retaining
pins. (See Figure 2.)
9. Assemble fingers as
shown in figures 3 and 4.
10. Insert columnating plate
so the step goes under the
lip of the finger housing and
the plate lies flush with the
housing side edge.
11. Install cover by sliding it
on the small end.
12. Insert assembled finger
through door opening
starting with lower left.
NOTE: The customer MUST
tell you what position to
place the assembled finger
in for their application.
13. Install finger in the
oven by sliding it over
the plenum flange and
setting the front bracket.
(See Figures 6 and 7.) BE
SURE THAT THE FINGER
SITS SQUARELY OVER THE
PLENUM FLANGES AND
THE HOLES POINT IN THE
PROPER DIRECTION. Top
fingers point down, bottom
fingers point up. (See Figure 8.)
20
Figure 1
Figure 2
Figure 3
Figure 4
14. Repeat step 11 until all ten (10)
fingers are installed.
15. Install conveyor and crumb
pans before operation. See
"Weekly Cleaning" in Section 4 for
instructions.
16. Attach Motor Cover as shown
with bolts provided.
17. You are now ready for services
to be connected. This should be
done by licensed electricians and
plumbers. See "Specifications" section and "Installation
Requirements" section for more information.
Figure 6
Figure 8
Part Number 11020000487 Rev A (2/16)
Section 2
Figure 5
Figure 7
3240 Gas
3240 Electric