Oven Start-Up Instructions; To Turn A Conveyor Off Or Back On; Oven Shut-Down Instructions - Lincoln Impinger 3200 Serie Manuel D'entretien & Manuel D'installation

Operation

Oven Start-Up Instructions

n
All covers and access panels must be in place and
properly secured, before operating this equipment.
1. Turn oven on. After the oven is turned on, it is in
cooking mode. To set the time and temperature you
must be in programming mode.
2. To get to program mode, press and hold the time and
temperature buttons for approximately 6 seconds.
While pressing the buttons, the display will say "Hold
Key and Wait. " The display will then say "Please Release"
after the buttons have been held long enough. After
you release the buttons you will be in programming
mode.
3. The display will say "Set Point Temperature or Time
to Select Function. " If no buttons are pressed within 4
seconds the display will revert back to cooking mode.
It will automatically save the last settings that were
entered before reverting to cooking mode.
4. To set the temperature, press the Temperature button.
The set point temperature will be displayed and
the temperature may be increased or decreased by
pressing the Increase or Decrease buttons.
5. To set the belt time, press the Time button. The display
will indicate which belt is being set. Press the Increase
and Decrease buttons to increase or decrease time.
Press the Time button again to toggle between belts.
6. To save settings and return to cooking mode leave the
control alone for 4 seconds and it will revert to cooking
mode.
7. Preheat oven for minimum of 45 minutes before
cooking.
24
Warning

To Turn a Conveyor Off or Back On

(When configured with split belt)
1. When the oven is turned on, all belts will automatically
begin running. To turn one belt off, press and hold
one of the conveyor speed buttons, until the desired
conveyor is shown on the display.
2. While pressing the button, the display will show which
belt is being turned off. You will need to continue
holding the button for approximately four seconds.
3. The display will show "Please Release" when it is time to
let go of the button. The belt will turn off.
4. To turn the belt back on, press and hold the same
button that you did before.

Oven Shut-Down Instructions

1. Turn the ON/OFF switch to the "OFF" position. The oven
will now shut down and cease operation.
Part Number 11020000487 Rev A (2/16)
Section 3