Safety Precautions For Maintenance; Electrical Maintenance Interventions; General Checks On The Electrical System - Pramac GSW Manuel D'utilisation

6.2 Safety precautions for
maintenance
WARNING
Before performing any maintenance,
turn the selector switch with the
removable key to the "OFF" position
and disconnect the battery. This
prevents the generator from being
activated unexpectedly.
WARNING
Prevent risks of an electrical nature
by disconnecting the power from the
board before
maintenance by
specific key selector, isolating both
the main disconnecting switch (CP.1)
and the load disconnecting switch
and disconnecting the battery.
6.3 Electrical maintenance
interventions
DANGER
Verify there are
voltages before disassembling a
device or making
parts of it. Pay particular attention
when working
connected to capacitive
(capacitors) or
connections of which you are not
sure of their isolation.
94 6.MAINTENANCE
performing any
means of the
no residual
contact with
on circuits
loads
on external
NOTE
Pay attention
electronic circuits.
components are subject to being
damaged or broken by electrostatic
charges and therefore, also from
contact made with the human body.
Touch an isolated metal structure to
discharge your
before working on the component.
NOTE
Do not use compressed
remove the dust during the cleaning
operations of the electrical system.
Blowing compressed air inside the
panel can cause the components to
break and the conductors to loosen
from their clamps.
6.3.1 General checks on the
electrical system
Verify there is no water or condensation
infiltration
Make sure there is absolutely no water infiltration
•
or the formation of hazardous condensation.
Promptly check the sealing systems (gaskets).
•
Immediately remove water and perform the
•
necessary repairs.
Verify the tightness of the cables and
components
Check the tightness of the power cables and
•
connection bars.
Check the tightness of the clamps and wires on
•
the terminal boards by pulling the cables lightly.
Check the tightness of all the fixing screws of the
•
components, both in the control board and on the
generator.
Tighten the screws when necessary.
•
GSW
when handling
Many
potential charge
air to