Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
NOTE
If the generator is to be stored for a
long time after being transported
(over 30 days), follow the guidelines
provided
in the
service for long periods" paragraph).
4.1.4
Positioning
Refer to the installation diagram supplied with the
generator to learn how to position it.
4.2
Connecting the utilities
WARNING
The electrical connections must
only be carried out by specialised
personnel.
76
4.INSTALLATION
"Placing
out
of
WARNING
The following requirements for use
must be complied with to prevent
risks
posed
for
damage caused to the generator :
• Do not connect utilities to the
generator
unless
features are known or if these are
different
from
generator (e.g. different voltages
and/or frequencies).
• The total absorption of all the
equipment
simultaneously must be considered.
• All the generators are equipped
with
protections
current,
over-voltage
circuit.
In
any
intentionally connect loads with
maximum currents that exceed the
specifications of the sockets they
are connected to.
• Do not connect a number of
generators
in
equipped with the special parallel
board.
NOTE
All the connection operations of the
utilities
must
be
compliance
with
provided on the wiring diagrams.
4.2.1
Cable dimensions
The installer is responsible for the selection and
•
sizing of the cables who installs the system. Cables
with an inadequate section cause excessive drops in
voltage
and
the
cable
temperatures.
4.2.2
Cable arrangement
The set of cables used to connect the generator-
•
utility must be duly set up in a suitable channel or
passage, protected from making contact or being
crushed.
GSW
persons
and
the
electrical
those
of
the
connected
against
over-
and
short-
case,
do
not
parallel
unless
carried
out
in
the
guidelines
to
reach
hazardous
Hide quick links:
Publicité
Chapitres
Table des Matières
Dépannage
