Start Up Operations After A Long Idle Period - Pramac GSW Manuel D'utilisation

NOTE
If necessary, disconnect the battery
- always disconnect the negative
pole (2) first and then the positive
pole (3).
4.5 Start up operations after
a long idle period
WARNING
The operations
must only be
specialised personnel.
The following operations require an
in-depth knowledge of certain parts
of the engine.
manufacturer's documentation
the engine for further information or
if necessary, refer to specialised
personnel.
NOTE
Oil preservatives are marketed by
oil companies. Refer to the manual
of the engine
manufacturer of the engine to learn
the type.
described below
carried out by
See the
of
or contact the
Verify that all the windings of the alternator are
isolated before activating the generator after a long
idle period. If incorrect isolation values are detected,
it is recommended to consult the nearest PRAMAC
assistance centre.
Follow the specific guidelines provided in the
manuals of the relative manufacturers, according to
the type of engine, in order to carry out the restart
operations correctly. The main operations that must
be carried out are:
Remove any covers from the engine, air filter and
•
drain pipe.
If necessary, top-up
•
recommended by the manufacturer of the engine.
Unless done previously, replace the oil filters.
Fit the new fuel filters and bleed the system.
•
Check the transmission belt/s.
•
Check the condition of all the sleeves and tighten
•
the clamps.
Close the drain valves and fit any caps.
•
Check the level of the coolant. Top-up, if
•
necessary.
Connect the batteries after having charged them
•
completely.
Start the engine and let it warm up on minimum
•
before loading it.
Check that there is no oil, fuel or coolant leak.
•
4.INSTALLATION
GSW
the lubricant as
81