Pramac GSW Manuel D'utilisation page 80

Connections to panel type (B):
(Referring to previous image)
Remove the two fixing screws (1) and open the
•
protection panel.
Pass the cables through the bottom side of the
•
panel.
Connect the cable to the specific terminals (4)
•
following the indications on the wiring diagrams
supplied with the generator.
Close the protection panel and tighten the two
•
fixing screws (1).
Connections to panel type (C):
Remove the two fixing screws (1) and open the
•
protection panel (2).
Pass the cables through the bottom side of the
•
panel, blocking them with the specific clip (3).
Connect the cables to the specific terminals (4)
•
following the indications on the wiring diagrams
supplied with the generator.
78 4.INSTALLATION
Close the protection panel and tighten the two
•
fixing screws (1).
Connections to panel type (D):
Remove the two fixing screws (1) using the
•
appropriate spanner and open the protection panel
(2).
Pass the cables through the bottom side of the
•
panel through the specific opening positioned
underneath the electric panel (3).
Connect the cables to the specific terminals (4)
•
following the indications on the wiring diagrams
supplied with the generator.
Close the protection panel (2) and tighten the two
•
fixing screws (1) with the specific spanner.
GSW