Porter & Charles FEC60B Série Instructions D'installation page 20

H - Gas Cooktop Functions
B - Cooking Instructions
Automatic start-up with valves
Turn the corresponding knob anticlockwise up to the maximum position and press the knob.
Once the burner has been started up, keep the knob pressed for about 6 seconds.
Using the burners
In order to obtain the maximum yield without wasting gas, it is important that the diameter of the
pot is suitable for the burner potential (see the following table and fig.1). This is to avoid the flame
extremities being larger than the base of the pot. All of the operating positions must be chosen
between the high and the low settings, never between the high position and the closing point.
The gas supply can be interrupted by turning the knob clockwise up to the off position.
NOTE:
When the equipment is switched off, always check that the knobs are in the off position.
NOTE:
If there is no power supply, it is possible to light the burners with matches, setting the knob to the
high setting.
NOTE:
If the flame should blow out accidentally, the safety valve will automatically stop the gas supply,
after 20 - 30 seconds. To restore operation, turn the knob to the off position.
WARNING:
-Do not use sprays near the appliance in operation.
-Do not place unstable pots on the burner to prevent them from tipping or overflowing.
-Always turn gas off if moving a pot away from the appliance.
-While cooking with fat or oil, pay the utmost attention as these substances can catch fire when
overheated.
20