Porter & Charles FEC60B Série Instructions D'installation page 18

Note: If you have not turned the cooking function and temperature setting off, your oven will now
continue to operate manually. The AUTO symbol will disappear and the POT symbol will
reappear.
C
ANCELING AUTOMATIC SETTINGS
To cancel a program:
Press plus and minus button simultaneously for minimum 3 seconds.
Fully automatic – (Start Later – Stop Later)
Your oven may be programmed to start, cook for the desired time and turn off automatically.
This function is particularly useful in the preparation of the evening meal, should you be out
during the day, it will be ready on your return home. For example, if your cooking time is 45
minutes and you want the cooking to finish at 6.00 p.m.
1 Press the MODE button minimum for 4 seconds, display shows 00:00. Press the MODE
button again, display shows DUR. Set the cooking duration time for say 45 minutes using
the PLUS or MINUS button.
2 Press the MODE button again, display shows END. Set the stop cooking time to 6.00pm
(18:00hrs). Release and the display will return to the normal time of day after 7 seconds.
The AUTO symbol will be displayed.
3 Using the above settings, the oven is now programmed automatically to commence
cooking 45 minutes prior to 6.00 pm (18:00hrs). The AUTO symbol and the POT symbol
will be displayed. Then automatically turn off.
When cooking is complete the AUTO symbol is flashing and the POT symbol will
disappear and the alarm will sound. The alarm will turn off after pressing the MODE
button.
4 If you hold the MODE button longer then 4 seconds the oven will return to the normal
cooking mode.
NOTE:
On oven start up or possibly at other times, due to electricity supply deviations – the set
program may freeze on a function – if this occurs we recommend that, after checking other
solutions without success, it is recommended that power supply be disconnected to the
appliance and allow it to be in this position for 5 minutes before reconnecting. This may
clear the frozen position allowing you to reset the clock/timer for normal operation.
Cooling Fan
The oven is provided with a cooling fan motor to reduce the heat around the oven. The fan motor
is controlled by a sensor, which will start when the oven is switched on and stop working when
the temperature is reduced accordingly. This safeguards both the range and the adjoining
cupboards from the possibility of temperature damage.
Safety Thermostat
Your range is fitted with an over-temperature sensor that will automatically shut down your oven
for a period if it is deemed to be overheating- this sensor is fitted to the rear wall of the oven,
inside the outer case – it will only activate in extreme circumstances and is provided as protection
to the appliance and the adjoining furnishings. If activated it will shut down the appliance for a
short time and will automatically reset allowing normal operation – you should consult your
service technician if the problem re-occurs.
18