Technical Data; Specified Conditions Of Use - Güde USS 20-201-24 Mode D'emploi

ENGLISH
10

Technical Data

Reciprocating saw
Art. No
Battery voltage
Stroke rate under no-load
Lengths of stroke
Cutting depth max. in: Wood
Cutting depth max. in: Metal
Weight without battery/Charging equipment
Recommended Ambient Operating Temperature
Recommended battery types
Recommended charger
Noise details
Measured according to EN 62841; Uncertainty K = 3 dB (A)
Sound pressure level L
Sound power level L
Wear ear protectors!
Vibration details
Vibration total values (triaxial vector sum) determined according to EN 62841, Uncertainty K = 1,5 m/s
cutting boards
with sawblade Wood Vibration emission value a
Cutting wooden beams
with sawblade Wood Vibration emission value a
WARNING: The vibration emission level will vary because of the ways in which a power tool can be used and
may increase above the level given in this information sheet.
The vibration emission level may be used to compare one tool with another.
It may be used for a preliminary assessment of exposure.
An accurate estimate of the vibratory load should also take into account the times when the tool is shut down
or when it is running but not actually in use. This may significantly reduce the vibratory load over the total
working period.
Identify additional safety measures to protect the operator from the effects of vibration such as: maintain the
tool and the accessories, keep the hands warm, organisation of work patterns.
control elements and how to use the appliance
properly. Abide by all the safety measures stated in
the service manual. Act responsibly toward third
parties.
The operator is responsible for accidents or risks to
third parties.
Persons over 16 years of age can only work on the
appliance. An exception includes youngsters trained
in order to reach knowledge under supervision
of the trainer during occupational education.
In case of any doubts about connection and operati-
on refer please to our customer center
1)
pA
WA
Read and understand the operating
instructions before using the
appliance. Familiarise with the
h,B
h,WB

Specified Conditions Of Use

This sabre cut is intended to cut wood, plastic, and
metal. It can cut straight lines, curves, and internal
cut-outs. It cuts pipes and can cut flush to a surface.
Do not use this product in any other way as stated
for normal use. Not observing general regulations
in force and instructions from this manual does not
make the manufacturer liable for damages.
In spite of compliance with all relevant design regula-
tions, dangers may still present themselves when the
machine is operated, e.g.:
• noise emissions
• dust emissions
• vibrations to hand and arms
USS 20-201-24
58815
20 V
0-3000 min
-1
22 mm
115 mm
10 mm
1,74 kg
-18°C ... +40°C
AP 20-20, AP 20-40
LG 20-24, LG 20-35
82,31 dB(A)
93,31 dB(A)
2
18,73 m/s²
19,68 m/s²