CAMPAGNOLO ZONDA Manuel De L'utilisateur page 15

WARNING!
Incorrect rim / clincher tyre coupling may cause it to deflate, burst or detach suddenly and cause accidents, serious injuries or even death.
2.1 - INSTALLING CLINCHER TIRES
Be sure that you do not bend or otherwise damage any portion of the rim when installing
the tire.
• Insert one side of the clincher into the seat provided on the rim (Fig. 1).
• Slightly inflate the inner tube to facilitate assembly.
• Insert the valve through the hole in the rim, and then position the remainder of the inner
tube between the rim and the tyre.
• In order to install the tube on the rim, inflate the tube slightly first. You should then manually
set the tube and tire on the rim, making sure that the tube is positioned correctly within the
tire and that the tire is positioned correctly on the rim.
• Insert the second side of the tyre tire into its seat in the rim.
• You may then fully inflate the tube to the correct working pressure. Please inflate the tube
slowly, making sure that you maintain the correct positioning of the tube and tire on the rim.
WARNING!
Incorrect tire pressure could cause tire failure or loss of control of the bicycle, resulting in an accident, personal injury or death.
2.2 - INFLATING AND DEFLATING THE TIRE
• To inflate the tire: 1) remove the cap, 2) unscrew the valve, 3) inflate the tire using a compressor or pump equipped with a pressure gauge to obtain the
required pressure, then 4) tighten the valve and replace the cap.
• To deflate the tire: 1) remove the cap, 2) unscrew the valve, 3) press and hold down the valve to obtain the required pressure, then 4) tighten the valve
and replace the cap.
4
1