Cloning With A Multi Unit Charger (Muc) - Motorola Solutions PDX Série Mode D'emploi

Cloning with a Multi Unit Charger (MUC)

Pocket 1
"CLONE" symbol Pocket 2
To clone radios using the MUC, there must be at least
two radios:
• a Source radio (the radio which profiles will be
cloned or copied from) and
• a Target radio (the radio which profile will be
cloned from the source radio.)
The Source radio has to be in Pocket 1, 3 or 5 while
the Target radio has to be in Pocket 2, 4 or 6,
matching in the MUCs pockets by pairs as follows:
• 1 and 2 or,
• 3 and 4 or,
• 5 and 6 (*).
Pocket 4
"CLONE" symbol Pocket 5
When cloning, the MUC does not need to be plugged
into a power source, but ALL radios require charged
batteries.
1. Turn ON the Target radio and place it into one of
the MUC Target Pockets.
2. Power the Source radio following the sequence
below:
• Long Press the PTT button and SB2
simultaneously while turning the radio
ON.
• Wait for 3 seconds before releasing the
buttons until the audible tone "Cloning" is
heard.
3. Place the Source radio in the source pocket that
pairs with the target pocket you chose in step 1.
Press and release the SB1 button.
4. After cloning is completed, the Source radio will
announce either "successful" (cloning is
successful) or "fail" (cloning has failed). The
'successful' tone sounds like a good key 'chirp'
whereas the 'fail' tone sounds similar to a 'bonk'
tone. If the Source radio is a display model, it
53
English