Hands Free Without Accessories (Ivox); Setting Vox/Ivox Sensitivity; Toggle Voice Prompt In User Mode; Power Up - Tone Mode - Motorola Solutions PDX Série Mode D'emploi

Hands Free without Accessories (iVOX)

• Enable iVOX by pressing the PTT Button while
turning ON the radio.
• A short press of the PTT Button re-enables iVOX.
• There is a short delay between the time when you
start talking and when the radio transmits.

SETTING VOX/IVOX SENSITIVITY

The sensitivity of the radio's accessory or microphone
can be adjusted to suit different operating
environments. VOX sensitivity can be programmed
via the CPS.
Default value is OFF. If you want to use the VOX
feature, VOX level should be set at a different level.
• 1 = High audio input level will trigger the Tx
• 2 = Medium sensitivity
• 3 = Low audio input level will trigger the Tx
34
English

TOGGLE VOICE PROMPT IN USER MODE

Short press the SB1 Button while turning ON the radio
to enable/disable the Voice Prompt in User Mode.
(Default is set to ON).

POWER UP - TONE MODE

To enable/disable power up tone mode, press SB1
and SB2 buttons simultaneously for 2-3 seconds while
powering up the radio until you hear the pre-
programmed power up tone. Three different power-up
tones are available.

RESET TO FACTORY DEFAULTS

Reset to Factory Defaults will set back all radio
features to the original factory default settings. To do
so, press PTT, SB2 and SB1 simultaneously while
turning ON the radio until you hear a high tone chirp.

MICROPHONE GAIN

The sensitivity of the microphone can be adjusted to
fit different users or operating environments.
This feature can be adjusted only through the CPS.
Microphone default setting is set to level 2 (medium
gain).