Charging Using The Plug-In Charger; Charging A Radio And Battery Using A Multi-Unit Charger; Battery Meter; Attaching The Battery - Motorola Solutions DTR Série Guide De L'utilisateur

Masquer les pouces Voir aussi pour DTR Série:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

1-8

Charging using the Plug-in Charger

1. Plug the charger into an AC outlet.
2. Open the accessory connector cover.
3. Plug the other end of the charger into the accessory connector.
4. Disconnect the charger from the radio by pressing the two side buttons on the charger and
remove from the radio.

Charging a Radio and Battery using a Multi-Unit Charger

A Multi-Unit Charger (MUC) is available separately (RPN4040) which charges up to 6 radios,
batteries, or a combination of the two at the same time.
When charging a radio in the MUC, the battery icon on the radio display shows the charging status.
When charging a battery, the LED in front of the pocket indicates charging status. The LED is solid
red when the battery is charging, and solid green when charging is complete.

Battery Meter

The battery meter in the upper right corner of the radio display shows how much battery power is remaining:
Battery Type
Li-Ion

Attaching the Battery

1. If the battery door is already in place, slide the lock tab to the left to unlock the battery latch.
Push down on the latch and lift the battery door off the radio.
2. Insert the battery, printed arrows first, into the battery compartment and press down to secure
firmly in place.
3. Replace the battery door onto the radio and slide the latch into place. Slide the lock tab to the
right to lock the battery latch.
3 Bars
100%–85%
85%–25%
Accessory Connector
2 Bars
1 Bar
25%–10%
Introduction: Attaching the Battery
Flashing
Final 10%

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Dtr410Dtr550Dtr650

Table des Matières