Installing The Grass Collection Box; Filling With Engine Oil And Checking The Oil Level - Grizzly BRM 46-160 H Traduction De La Notice D'utilisation Originale

Installing
the Grass Collection Box
Caution: Do not operate the equip-
ment with the grass collection
box or impact protection installed
incompletely. Risk of injury!
Assemble grass catchment
basket:
1. Push basket rods (29) into bas-
ket net (22).
2. Pull plastic loops (28) over bas-
ket rods.
Fixing the Grass Collection
Box onto the Equipment:
3. Lift up shock protection (21).
4. Hook the grass collection box
(22) into the mounting provided
for this (30) on the rear of the
equipment.
5. Release the impact protection
(21). It holds the grass collec-
tion box in position.
Grass bag fi lling indicator
A textile display is attached to
the top of the grass bag (22).
At an empty grass bag infl ates
the fi ll indicator in the operating.
The fi ll indicator to coincide in
full catcher. In this case, imme-
diately empty the grass bag.
In heavily polluted grass bag fab-
ric the fi ll indicator can not infl ate
himself. The function of the check
indicator is not guaranteed. Imme-
diately clean the grass bag fabric.
Dismantling/Empty out the
Grass Collection Box:
6. Lift the impact protection (21)
and remove the grass collection
box (22)
7. Empty catchment basket (see
chapter „Disposal / Environmen-
tal Protection") and re-install it.
Filling with Engine Oil and
Checking the Oil Level
Place the equipment on a level
base.
1. Unscrew the oil fi ller cap and
dipstick (16) and pour oil into
the tank. Use brand oil (e.g.
SAE 10W30).
2. To check the oil level, wipe the
dipstick (16) on a clean cloth
and replace it in the tank until it
stops.
3. After pulling it out, read
off the oil level on the
dipstick. The oil level
should be in line with
the upper edge of the
mark.
4. Wipe off any spilt oil and
close the oil fi ller cap (16).
Check the oil level every time be-
fore mowing and add oil before the
lower marking point is reached.
GB
87