Log Placement - Napoleon GDI-30N Mode D'emploi Et Installation

4.5

LOG PLACEMENT

FAILURE TO POSITION THE LOGS IN ACCORDANCE WITH THESE DIAGRAMS OR FAILURE TO USE
ONLY LOGS SPECIFICALLY APPROVED WITH THIS APPLIANCE MAY RESULT IN PROPERTY
LOGS MUST BE PLACED IN THEIR EXACT LOCATION IN THE APPLIANCE. DO NOT MODIFY THE
PROPER LOG POSITIONS, SINCE APPLIANCE MAY NOT FUNCTION PROPERLY AND DELAYED
THE LOGS ARE FRAGILE AND SHOULD BE HANDLED WITH CARE.
TM
PHAZER logs and glowing embers exclusive to Napoleon, provide a unique and realistic glowing effect that is
different in every installation. Take the time to carefully position the glowing embers for a maximum glowing effect.
Log colours may vary. During the initial use of the appliance, the colours will become more uniform as colour
pigments burn in during the heat activated curing process.
A. Place the rear log so that it rests against
the two log brackets on the back wall of the
fi rebox. The air space between the log and
fi rebox back is used to facilitate combustion
air fl ow.
C. Position the front right log just behind the
grate. Line up the log with the studs located
on the log support.
D
E. Line up the square hole in the right crossover
with the square post located on the right
side of log and install as shown.
!
DAMAGE OR PERSONAL INJURY.
IGNITION MAY OCCUR.
A
A C
B
E
A
C
B
WARNING
B. Move the charcoal strip into position lining
up the holes in the bottom with the studs
located on the burner. Ensure strip sits fl at on
the burner.
D
D. Move the left log into position lining up the
hole in the bottom with the stud on the left
side of the log support.
D
F. Line up the rectangular hole in the left
crossover with the rectangular post located
on the left side of log and install as shown.
76.1A
A
B
A
C
B
F
E
A
C
B
W415-1365 / A / 07.28.16
15
EN