Finishing; Minimum Mantel Clearances - Napoleon GDI-30N Mode D'emploi Et Installation

12

4.0 FINISHING

EN
IF FINISHING THE FRONT OF THE APPLIANCE, IT MUST BE FINISHED WITH ANY NON-COMBUSTIBLE
DO NOT STRIKE, SLAM OR SCRATCH GLASS. DO NOT OPERATE APPLIANCE WITH GLASS
FACING AND/OR FINISHING MATERIAL MUST NEVER OVERHANG INTO THE APPLIANCE OPENING.
4.1

MINIMUM MANTEL CLEARANCES

RISK OF FIRE, MAINTAIN ALL SPECIFIED AIR SPACE CLEARANCES TO COMBUSTIBLES. FAILURE
TO COMPLY WITH THESE INSTRUCTIONS MAY CAUSE A FIRE OR CAUSE THE APPLIANCE TO
OVERHEAT. ENSURE ALL CLEARANCES (I.E. BACK, SIDE, TOP, VENT, MANTEL, FRONT, ETC.) ARE
WHEN USING PAINT OR LACQUER TO FINISH THE MANTEL, THE PAINT OR LACQUER MUST BE
Combustible mantel clearance can vary according to the mantel depth. Use the graph to help evaluate the
clearance needed. These same requirements apply to any combustibles protruding on either side of the
appliance.
W415-1365 / A / 07.28.16
NEVER OBSTRUCT THE FRONT OPENING OF THE APPLIANCE.
MATERIAL SUCH AS BRICK, MARBLE, GRANITE, ETC.
REMOVED, CRACKED, BROKEN OR SCRATCHED.
HEAT RESISTANT TO PREVENT DISCOLOURATION.
15" (381mm)
14" (356mm)
13" (330mm)
12" (305mm)
3 4
(76mm) (102mm) (127mm) (152mm)
MANTEL DEPTH
WARNING
!
RISK OF FIRE!
WARNING
!
CLEARLY MAINTAINED.
6" (152mm) MANTEL
15"
(381mm)
5 6
TOP OF APPLIANCE
72.1B
73.1
5"
4"
3"
14"
(356mm)
13"
(330mm)
12"
(305mm)