A
C. Place the right middle log (W135-0368) onto the far
right locating stud on the front deflector.
A
E
E. Place the left middle log (W135-0369) onto the far
left locating stud located on the front deflector.
A
D
E
G
G. Slide the flat portion of the front middle log (W135-
0374) under the second grate post.
A
H
E
G
2.7
glowing embers
WARNING
!
•
Do not block or close off the burner ports. Blocked ports can cause an incorrect fl ame pattern, carbon
deposits and delayed ignition.
Tear the embers into pieces and loosely layer above the burner ports covering the burner area. Care should be
taken to shred the embers into thin, small irregular pieces as only the exposed edges of the fi bre hairs will glow.
The ember material will only glow when exposed to direct fl ame; however, care should be taken to not
block off the burner ports.
Blocked burner ports can cause an incorrect fl ame pattern, carbon deposits and delayed ignition. PHAZER™
logs glow when exposed to direct fl ame. Use only certifi ed "glowing embers" and PHAZER™ logs available from
your local authorized dealer / distributor.
All manuals and user guides at all-guides.com
B
C
B
D
C
B
F
C
I
B
D
C
F
A
D
D. Place middle log (W135-0370) onto the two center
locating studs on the front support.
A
E
F.
Place the notch of the front right log (W135-0373)
onto the third grate.
A
H
E
H. Place the pin into the log locating hole of log A and
place the left crossover log (W135-0372) onto the
pin, allowing the bottom to rest on log E.
I.
Place the pin into the log locating hole of log B and
place the right crossover log (W135-0371) onto the
pin, allowing the bottom to rest on log C.
J. If GL81L2 (upgrade kit) is purchased repeat "H"
and "I" on other side.
installation
B
C
B
D
F
C
B
C
D
F
G
22.1
W415-0713 / E / 05.10.18
EN
5