Replacing The Backing Pad - MIRKA AROP-B 312NV Mode D'emploi

en
AROP-B: 4,000–7,000 rpm. The speed can be adjusted between 4,000 and max rpm by adjusting the position of the
trigger In active mode the max rpm can be adjusted by pressing rpm+ or rpm–, Figure 1 The rpm can be adjusted in
steps of 4,000, 4,500, 5,000, 5,500, 6,000, 6,500 and 7,000 rpm
ARP-B: 1,500–2,200 rpm. The speed can be adjusted between 1,500 and max rpm by adjusting the position of the
trigger In active mode the max rpm can be adjusted by pressing rpm+ or rpm–, Figure 1 The rpm can be adjusted in
steps of 1,500, 1,600, 1,700, 1,800, 1,900, 2,050 and 2,200 rpm
• The rpm can be locked to prevent an accidental rpm change Wait until the polisher is not in active mode
Simultaneously press and hold both rpm+ and rpm– buttons and then pull the switch trigger In order to unlock the
tool, repeat same operation If rpm+ or rpm– is pressed in speed lock mode the right led flashes red twice but no
speed change occur
• When polishing, always place the tool on the work surface before starting the tool Always remove the tool from the
work surface before stopping it This will prevent gouging of the work surface due to excess speed of the polishing
pad
• When polishing is finished, remove the battery from the polisher by simultaneously pressing the button on both
sides and removing the battery from the tool Charge the battery
Bluetooth
This tool is equipped with Bluetooth low energy technology and can be connected to an App from which additional
tool functionality can be accessed For more information on the App functionality and if it is available in your country,
go to www mirka com
Activate Bluetooth on your Mirka® AROP-B and Mirka® ARP-B as follows:
1 Connect the battery to the tool
2 Press and hold the rpm+ button while activating the tool by pressing the switch trigger
3 Middle LED is flashing green, to indicate that Bluetooth is active and ready for connections
4 Middle LED is lit green when the tool is connected to another Bluetooth device
5 Bluetooth is deactivated when the tool is deactivated/turned off
NOTE! If the App is not installed or if it is not available in your country, Bluetooth shall not be activated
The Bluetooth® word mark and logos are registered trademarks owned by the Bluetooth SIG, Inc and any use of such
marks by Mirka Ltd is under license Other trademarks and trade names are those of their respective owners
Maintenance
Always remove the battery before maintenance!
Only use original Mirka spare parts!

Replacing the backing pad

1 Hold the spindle with the pad wrench
2 Turn the backing pad counterclockwise to remove it
3 Fit and tighten the new backing pad using the pad wrench
Further service
Servicing must always be performed by trained personnel To keep the tool warranty valid and ensure optimal tool
safety and function, servicing must be carried out by a Mirka authorized service center To locate your local Mirka
authorized service center, contact Mirka Customer service or your Mirka dealer
60
Mirka® AROP-B 312NV & ARP-B 300NV • 77 mm (3") • 10.8 V