Getting Started - MIRKA AROP-B 312NV Mode D'emploi

• The charging process will last approximately 40 minutes for the BPA 10820, 50 minutes for the BPA 10825 and 100
minutes for the BPA 10850 battery pack
NOTE: This charger can only charge Mirka 10 8 V battery packs
NOTE: Charging times may be longer depending on the ambient temperature and battery condition
LED indication of 10.8 V charger
LED
3
2
1
Pre-charge
(Trickle charge)
Steady glow
Charger diagnostics
The charger will indicate if:
• A battery pack is overheated All three charging lights will flash Remove the battery, allow it to cool down for 15–30
minutes and re-insert
• A malfunction occurs in the battery or the charger Two charging lights will flash Remove the battery and allow it to
cool down Re-insert the battery pack into the charger If two charging lights still flash, the battery or charger may
require service

Getting started

• When unpacking the tool, make sure it is intact, complete and has not been damaged in transport Never use a
damaged tool
• Before use, check that the backing pad is correctly mounted
• Insert the fully charged battery pack into the polisher until it locks in place with a click
Operating instructions
• The tool is intended to be operated as a hand-held tool It can be used in any position
• Select a suitable polishing pad and secure it to the backing pad Make sure the polishing pad is centered on the
backing pad
• You power on and start the polisher by pressing the switch trigger
• The polisher will run as long as the trigger is pressed When the trigger is released, the polisher stops but remains in
active mode for a short time before it automatically deactivates / powers off
• When polisher is in active mode, the right LED is green
• When an intelligent battery is used, all three LEDs will flash green for three seconds during startup
• In active mode, the left LED shows the battery status:
– Green: Battery charge level is OK
– Flashing green: Battery charge level is below 75%
– Flashing green/red: Battery charge level is below 50%
– Flashing red: Battery charge level or battery health (only available with intelligent battery) is under 25%
– Red: Battery voltage too low, polisher is not operable
Charging... Charging...
Flashing
Charging finished Over temperature
Mirka® AROP-B 312NV & ARP-B 300NV • 77 mm (3") • 10.8 V
en | us • ca
Battery failure
253