Replacing The Backing Pad - MIRKA DEROS 325CV Instructions D'utilisation

en
Maintenance
Always disconnect the power before maintenance!
Only use original Mirka spare parts!

Replacing the backing pad

1 Insert the pad wrench between the backing pad and brake seal to hold the spindle nut
2 Turn the backing pad counterclockwise to remove it
3 Fit and tighten the new backing pad with washers
4 Remove the pad wrench
Pad saver
Mirka's pad savers are designed to protect the backing pad from wear and tear, when sanding aggressively and
continuously with net products These cost effective pad savers, placed between the backing pad and the sanding disc,
should be changed regularly The pad savers prolong the life of the backing pad
https://www mirka com/accessories/pad-savers/
Replacing the brake seal
NOTE! Too much vacuum in your dust extraction system may cause the brake seal to malfunction
1 Remove the backing pad as described above
2 Pull the old brake seal out of its groove
3 Fit the new brake seal in the groove
4 Fit the backing pad as described above
5 Check the brake seal function By changing the number of washers between the spindle and backing pad,
the effect of the brake seal can be adjusted
Further service
Servicing must always be performed by trained personnel To keep the tool warranty valid and ensure optimal tool
safety and function, servicing must be carried out by a Mirka authorized service centre To locate your local Mirka
authorized service centre, contact Mirka Customer Service or your Mirka dealer
56
Mirka® DEROS • 77 mm (3"), 125 mm (5") & 150 mm (6") • 230 V