Replacing The Backing Pad - MIRKA DEOS Instructions D'utilisation

en
Maintenance
Always disconnect air supply before maintenance!
Use only original Mirka spare parts!

Replacing the backing pad

The backing pad is fixed with 8 screws .
A = 8 mm (only on 70 x 198 mm)
B = 16 mm
Remove
1 . Turn the tool upside down .
2 . Remove the 4 screws (A) .
3 . Remove the 4 screws (B) .
4 . Remove the backing pad .
Install
1 . Fit the new pad .
2 . Fit the 4 screws (B) .
3 . Fit the 4 screws (A) .
4 . Finally tighten all 8 screws .
Pad saver
Mirka's pad savers are designed to protect the backing pad from wear and tear, when sanding aggressively and
continuously with net products . These cost-effective pad savers, placed between the backing pad and the sanding
strip, should be changed regularly . The pad savers prolong the life of the backing pad .
http://www .mirka .com/accessories/Pad_Savers/
Further service
Servicing must always be performed by trained personnel . To keep the tool warranty valid and ensure optimal tool
safety and function, servicing must be carried out by a Mirka authorized service center . To locate your local Mirka
authorized service center, contact Mirka Customer service or your Mirka dealer .
12
Mirka® DEOS • 81 x 133 mm (3" x 5") & 70 x 198 mm (3" x 8")
A
B
A
B
B
A
B
A