Battery And Charger; Charging Procedure - MIRKA AROP-B 312NV Mode D'emploi

en
Noise and vibration information
Measured values are determined according to EN 60745
Sound pressure level (L
Sound power level (L
Sound measurement uncertainty K
Vibration emission value a
Vibration emission uncertainty K *
Specifications subject to change without prior notice Model range may vary between markets
* In order to reflect normal working conditions of the polisher the operating conditions did deviate from the
standard method as follows: Grain size of the polishing compound was 5 μm Feed force was 10 N
The values stated in the table are derived from laboratory testing in conformity with stated codes and standards and
are not sufficient for risk evaluation Values measured in a particular work place may be higher than the declared
values The actual exposure values and amount of risk or harm experienced by an individual are unique to each
situation and depend upon the surrounding environment, the way in which the individual works, the particular
material being worked, work station design and the user's exposure time and physical condition Mirka Ltd accepts
no responsibility for the consequences of using declared values instead of actual exposure values for any individual
risk assessment
Further occupational health and safety information can be obtained from the following websites:
https://osha europa eu/en (Europe) or http://www osha gov (USA)
Proper use of tool
This polisher is designed for polishing all types of materials such as paints, metals, wood, stone, plastics, etc , using
polish specially designed for this purpose Do not use this polisher for any other purpose than that specified without
consulting the manufacturer or the manufacturer's authorized supplier Do not use backing pads with an operating
speed of less than 8,000 rpm free speed Any maintenance or repair work requiring the motor housing to be opened
may only be carried out by an authorized service center

Battery and charger

• The battery pack is not fully charged out of the carton First read the safety instructions and then charge your battery
according to the instructions
• For optimal charging capacity the battery should be charged at an ambient temperature between 18 °C (64 °F) and
24 °C (75 °F) To prevent damage to the battery pack, do not charge the battery pack where the air temperature is
below 4 °C (39 °F) or above 40 °C (104 °F)
• To obtain the longest possible battery life, we suggest the following:
– Store and charge your battery in a cool area Temperatures above or below normal room temperature will shorten
battery life
– Never store the battery in a discharged condition Recharge it immediately after it has been discharged
• All batteries gradually lose their charge The higher the temperature, the quicker they lose their charge
If you store your tool for long periods of time without use, recharge the battery every month This practice will prolong
battery life

Charging procedure

• Connect the power cord to the charger, and then plug into an outlet before inserting battery pack All three charging
lights will be on for two seconds and then turn off
• Insert the battery pack into the charger
• During the charging process, the charging lights will indicate the status as follows:
– Three charging lights will flash in sequence during the charging process
– Fully charged, all three lights will remain on continuously
58
Mirka® AROP-B 312NV & ARP-B 300NV • 77 mm (3") • 10.8 V
)
pA
)
WA
*
h
Mirka® AROP-B 312NV
60 0 dB(A)
71 0 dB(A)
3 0 dB(A)
6 9 m/s
2
1 5 m/s 2
Mirka® ARP-B 300NV
57 0 dB(A)
68 0 dB(A)
3 0 dB(A)
1 8 m/s
2
1 5 m/s 2