Bluetooth; Replacing The Backing Pad - MIRKA DEROS 550X CV Mode D'emploi

en

Bluetooth

This tool is equipped with Bluetooth® low energy technology and can be connected to an App from which additional
tool functionality can be accessed . For more information on the App functionality and if it is available in your country,
go to www .mirka .com .
Activate Bluetooth on your Mirka® DEROS as follows:
1 . Connect the power cord to mains outlet .
2 . Press and hold the + button while switching the tool on with the On/Off button .
3 . Left LED lights up (green), to indicate that Bluetooth is active .
4 . Bluetooth is deactivated when the tool is disconnected form mains outlet .
NOTE! If the App is not installed or if it is not available in your country, Bluetooth shall not be activated .
The Bluetooth® word mark and logos are registered trademarks owned by the Bluetooth SIG, Inc . and any use of such
marks by KWH Mirka Ltd is under license . Other trademarks and trade names are those of their respective owners .
Compliance with the radio regulations in North America has been verified in accordance with FCC Part 15 subpart
B and C, RSS-GEN, RSS-247 and FCC §15 .247 .
Maintenance
Always disconnect the power before maintenance!
Only use original Mirka spare parts!

Replacing the backing pad

1 . Insert the pad wrench between the backing pad and brake seal to hold the spindle nut .
2 . Turn the backing pad counterclockwise to remove it .
3 . Fit and tighten the new backing pad with two washers .
4 . Remove the pad wrench .
Pad saver
Mirka's pad savers are designed to protect the backing pad from wear and tear, when sanding aggressively and
continuously with net products . These cost effective pad savers, placed between the backing pad and the sanding disc,
should be changed regularly . The pad savers prolong the life of the backing pad .
http://www .mirka .com/accessories/Pad_Savers/#/
12
Mirka® DEROS • 125 mm (5") & 150 mm (6") • 110 V