How To Get Started; Replacing The Backing Pad - MIRKA LEROS 950CV Instructions D'utilisation

How to get started

When unpacking the tool, make sure it is intact, complete and has not been damaged in transport Never use a
damaged tool
Before use, check that the backing pad is correctly mounted and tightened Connect the power cord to the sander
Connect the power cord to a grounded outlet (220–240 VAC, 50/60 Hz)
In order to get the maximum performance from this tool it is recommended to use it with the Mirka dust extractor
and Mirka Net Sanding products
The power cord from the sander is connected to the mains supply on the front of the dust extractor By connecting
the sander's power cord to the outlet on the dust extractor it is possible to use the dust extractor's autostart function
Operating instructions
• The tool is intended to be operated as a hand-held tool The tool can be used in any position Note! The sander can
develop a torque reaction when started
• Make sure the sander is switched off Select a suitable abrasive and secure it to the backing pad Make sure the
abrasive is centered on the backing pad For optimal performance we recommend a Mirka backing pad and Mirka
Net Sanding product
• Switching on, changing speed and stopping the sander are described in Figures 2 and 3
• The max rpm can be adjusted by pressing rpm+ or rpm–, Figure 3 The rpm can be adjusted in the range 4,000 to
8,000 rpm
• When sanding, always place the tool on the work surface before starting the tool Always remove the tool from the
work surface before stopping it This will prevent gouging of the work surface due to excess speed of the abrasive
• It is strongly recommended that the tool is used in combination with a Mirka Dust Extractor
Maintenance
Always disconnect the power before carrying out maintenance!
Only use original Mirka spare parts!

Replacing the backing pad

Tools required: Hex socket 19 mm and Phillips screwdriver
1 Remove the cover cap Untighten the screw to remove the backing pad
2 Remove the screw
3 Remove the old pad
4 Attach the new backing pad to the spindle (aligned correctly) and tighten the pad screw with the hex socket
5 Attach the cover cap
Replacing the backing pad and interface
Tools required: Flat head screwdriver
Pad with grip: Change as described in section replacing backing pad
Plain pad with interface:
1 Remove screws (8 pcs)
2 Remove the interface
3 Removing and attaching backing pad See section above "Replacing the backing pad"
4 Fit a new interface
5 Refit screws (8 pcs)
Mirka® LEROS Random Orbital Sander • 225 mm (9")
en
45