MIRKA AROP-B 312NV Mode D'emploi page 252

en | us • ca
Noise and vibration information
Measured values are determined according to EN 60745
Sound pressure level (L
Sound power level (L
Sound measurement uncertainty K
Vibration emission value a
Vibration emission uncertainty K *
Specifications subject to change without prior notice Model range may vary between markets
* To reflect normal working conditions, the operating conditions during the test deviated from the standard
method as follows: The grain size of the polishing compound was 5 μm Feed force was 10 N
The values in the table are derived from laboratory testing in conformity with specified codes and standards and are
not sufficient for risk evaluation Values measured in a particular workplace may be higher than the declared values
The actual exposure values and amount of risk or harm experienced by an individual are unique to each situation
and depend on the surrounding environment, individual work styles, the particular material being worked, work
station design and the user's exposure time and physical condition Mirka Ltd accepts no responsibility for the
consequences of using declared values instead of actual exposure values for any individual risk assessment
Further occupational health and safety information is available on the following websites:
https://osha europa eu/en (Europe) or http://www osha gov (USA)
Proper use of the tool
This polisher is designed for polishing all types of materials such as paints, metals, wood, stone, plastics, etc , using
polish specially designed for the given material Do not use this polisher for any other purpose than that specified
without consulting the manufacturer or the manufacturer's authorized supplier Do not use backing pads with an
operating speed of less than 8,000 rpm free speed Any maintenance or repair work requiring the motor housing to be
opened may only be performed by an authorized service center
Battery and charger
• The battery pack is not fully charged out of the carton Read the safety instructions first and then charge the battery
accordingly
• For optimal charging capacity, the battery should be charged at an ambient temperature between 18 °C (64 °F) and
24 °C (75 °F) To prevent damage to the battery pack, do not charge where the air temperature is below 4 °C (39°F) or
above 40 °C (104 °F)
• For the longest possible battery life, we suggest the following:
– Store and charge your battery in a cool area Temperatures above or below normal room temperature will shorten
battery life
– Never store the battery in a discharged state Recharge it immediately after discharge
• All batteries gradually lose their charge The higher the temperature, the quicker this happens
If you store your tool for long periods of time without use, recharge the battery every month This practice will prolong
battery life
Charging procedure
• Connect the power cord to the charger and plug into an outlet before inserting the battery pack All three charging
lights will glow for two seconds and then go out
• Insert the battery pack into the charger
• During the charging process, the charging lights will indicate the status as follows:
– The three charging lights will flash in sequence during the charging process
– When fully charged, all three lights will glow steadily
252
Mirka® AROP-B 312NV & ARP-B 300NV • 77 mm (3") • 10.8 V
)
pA
)
WA
*
h
Mirka® AROP-B 312NV
60 0 dB(A)
71 0 dB(A)
3 0 dB(A)
6 9 m/s
2
1 5 m/s 2
Mirka® ARP-B 300NV
57 0 dB(A)
68 0 dB(A)
3 0 dB(A)
1 8 m/s
2
1 5 m/s 2