Starting Up - WAGNER W 850 E Mode D'emploi

4
48
6
A
A

Starting up

1. Attach air hose.
Device end (fig 4)
Place air hose end with pin in guide.
Secure by turning.
Spray gun end (fig. 5)
Place the air hose firmly into the
connection on the spray gun.
Any position can be chosen for
connection.
2. Unscrew the container from the spray
gun.
3. Adjust the ascending pipe
accordingly.
It should be possible to spray the
contents of the container leaving
hardly any material left in the
container.
5
Spraying with horizontal objects
(fig. 6)
Turn ascending pipe A forwards
Spraying overhead objects (fig. 7)
Turn ascending pipe A to point
backwards.
4. Fill container with coating material.
Screw firmly onto spray gun.
5. Place the spray gun in the spray gun
holder.
6. Only place the device on even and
clean surfaces. Device could suck up
dust, etc.
7. Before connecting to the mains
ensure that the mains voltage
corresponds to the details on the
rating plate.
8. Remove the spray gun from the spray
7
gun holder and point at object to be
sprayed. Tun on using ON/OFF
switch on the device.
9. Adjust the spraying pattern and
amount of material; set the amount of
air and pressure, see fig. 8, 9, 10, 11
and the description page 50.
10. Open trigger on the spray gun.
Note:
When the device is switched on air will
flow continually from the air cap.
GB