Speed Feedback - Parker 690+ Flux Vector Démarrage Rapide

English
Reference
Speed potentiometer across 1(low),

9(high), 2(wiper) OR
External 2-wire speed reference between

1(-) and 2(+)

Speed Feedback

•
The Speed Feedback Card is required only for closed
loop Flux Vector Control
Static Sensitive Board. Install only with
power OFF and follow proper
static/grounding procedures
• Install it on the feedback header, shown by the red arrow
in the figure. Ensure a good fit by securely snapping in
place.
• DIP switches 1,2,3,4 (blue arrow) set the threshold voltage
of the encoder signals. Set all switches to ON (up position)
for complementary encoder signals.
• Encoder connections to terminal block are:
1 Encoder Supply positive (5–15VDC)
2 Encoder Supply negative (0V)
3 Channel A
4 Channel A complement
5 Channel B
6 Channel B complement
CAUTION
Sequencing
Jumper 19 and 20 if no external trip contact

Start contact between 12 and 20

Jog contact between 16 and 20

Reverse Direction contact between 15 and 20

Health volt-free contacts between 21 and 22

Running volt-free contacts between 23 and 24

1-4