Power On; Calibration; Autotune - Parker 690+ Flux Vector Démarrage Rapide

Power On

Calibration

All calibration is done in software, through the keypad.
SCROLL
UP
AC MOTOR DRIVE
4.0KW 400V
OPERATOR
Menu at Level 1
DIAGNOSTICS
Menu at Level 1
QUICK SETUP
Menu at Level 1
The following is a list of the relevant parameters that you may need to check before starting the drive. Several of
these may not need adjustment if you are running a standard 60Hz, 460V 1800 RPM induction motor
1. Control Mode
2. Max Speed
3. Min Speed
4. V/Hz shape
5. Motor Current
6. Motor Base Freq
7. Motor Voltage
8. Nameplate RPM
9. Motor Poles
10. Encoder Supply
11. Encoder Lines
12. Encoder Invert
13. Autotune Enable

AUTOTUNE

Note: In V/Hz mode Autotune is not necessary and will not activate.
• In the QUICK SETUP menu, set AUTOTUNE ENABLE to TRUE
• MAX SPEED should be greater than NAMEPLATE RPM for a successful autotune
• On the keypad press L/R for LOCAL mode
• Ensure that the motor is uncoupled and free to rotate without causing problems
Press RUN. Drive will begin autotuning, The drive will stop without errors if autotune is successful
•
• Go to SYSTEM\SAVE CONFIG\APPLICATION and UP arrow to save your settings
ESCAPE ONE LEVEL
SCROLL
DOWN
ENTER MENU
1.3
Select the intended operating mode
Set max speed in RPM
Set min speed in %
Choose fan only for square curve
Motor full load current
Motor nameplate frequency
Motor nameplate voltage
Motor nameplate RPM
for 1800rpm=4, for 1200rpm=6
set between 5-15V to match encoder
Pulses per Revolution of encoder
Changes polarity of encoder feedback
Drive will Autotune if started
The 690+ can also be calibrated using the programming tool
software.
This is the power-up welcome screen. If a different screen
appears, press E a few times to return to this screen.
Press the M key to get to OPERATOR level.
DOWN arrow to get to the DIAGNOSTICS menu.
DOWN arrow to get to the QUICK SETUP menu.
Press M to enter QUICK SETUP and set the parameters relevant
to the operating mode of the drive by scrolling UP or DOWN.
1-5
V/Hz SV Vector
x x
x x
x x
x
x x
x x
x x
x x
x x
x
English
x
x
x
x
x
x
x
x
x
x
x
x