Filling With Petrol; Setting The Cutting Height; Adjust Front Wheels; Operation - Grizzly BRM 56-163 BSA Quattro Traduction De La Notice D'utilisation Originale

Check the oil level every time be-
fore mowing and add oil when the
lower marking point is reached.

Filling with Petrol

Warning! Petrol is flammable
and hazardous to health:
- Keep petrol in containers intended for
this purpose;
- Only refuel outdoors and never with
the engine running or when the ma-
chine is hot;
- Open the filler cap carefully to allow
excess pressure to escape;
- Do not smoke whilst refuelling;
- Avoid skin contact and inhalation of
the fumes;
- Remove spilt petrol;
- Keep petrol away from sparks, open
flames and other ignition sources;
- Do not use petrol/oil mixtures;
- Use normal or super unleaded
petrol;
- Only use clean, fresh petrol;
- Do not store petrol for longer
than one month, as its quality
deteriorates
1. Unscrew the filler cap (
pour in the petrol to the lower edge of
the filler.
Do not fill the tank entirely, to allow
the petrol room to expand.
2. Wipe away petrol residues around the
filler cap and close the filler cap.

Setting the Cutting Height

The equipment has 6 positions for setting
the cutting heigh (25-75 mm):
1. Pull the lever (18) outwards and
push it to the desired position .
2. Push the lever back in.
The correct cutting height is around
25 – 45 mm for an ornamental lawn and
around 40 – 65 mm for a utility lawn.

Adjust front wheels

The lawn mower is extremely flexible
and manoeuvrable thanks to the special
construction of the front wheels.
These are to be adjusted according to the
specific situation as follows:
8) and

Operation

Starting and Stopping the
Engine
Select a greater cutting height for
the first cut of the season.
1. The alignment of the wheel is
fixed once the clamping bra-
ckets (28) snaps into place. If
the wheel is desired in another
running direction, lift clamping
bracket to release it. Bring
wheel into new position and
clamping brackets snaps into
place once again.
2. Should the front wheels remain
able to move freely, lift the clam-
ping brackets (28) and do not
place them in the opening, but
rather set them on the plate be-
side it.
Observe noise control and local
regulations.
Warning! Petrol is flammable.
Start the engine at least 3 m
away from the filling location.
Start the equipment on a sturdy,
level base, if possible not in long
UK
99