Using The Cooling Device - Mobicool MCF 32 Notice D'utilisation

Operation
In "HIGH" mode, the battery monitor responds faster than at the levels "LOW"
and "MED" (see the following table).
Battery monitor mode
Switch-off voltage at 12 V
Restart voltage at 12 V
Switch-off voltage at 24 V
Restart voltage at 24 V
Proceed as follows to select the battery monitor mode:
➤ Switch on the cooling device.
➤ Press the "SET" button three times.
➤ Use the "+" and "–" buttons to select the battery monitor mode.
✔ The selected mode then appears in the display for a few seconds. The dis-
play flashes several times before it returns to the current temperature.
I
NOTE
When the cooling device is supplied by the vehicle battery, select
the battery monitor mode "HIGH". If the cooling device is con-
nected to a supply battery, the battery monitor mode "LOW" will
suffice.
6.5

Using the cooling device

A
NOTICE! Danger of overheating!
Ensure at all times that there is sufficient ventilation so that the heat
that generated during operation can dissipate. Ensure that the ven-
tilation slots are not covered. Make sure that the cooling device is
sufficiently far away from walls and other objects so that the air can
circulate.
➤ Place the cooling device on a firm foundation.
I
NOTE
Place the cooling device as shown (fig. 1, page 3). If you operate
the cooling device in a different position it can be damaged.
14
MCF32, MCF40, MCF60, FR40 AC/DC
LOW
10.1 V
11.1 V
21.5 V
23.0 V
MED HIGH
11.4 V 11.8 V
12.2 V 12.6 V
24.1 V 24.6 V
25.3 V 26.2 V
EN