Using The Battery Monitor - Mobicool MCF 32 Notice D'utilisation

MCF32, MCF40, MCF60, FR40 AC/DC
A
NOTICE! Danger of damage!
Disconnect the cooling device and other consumer units from the
vehicle battery before you connect the vehicle battery to a quick
charging device.
Overvoltage can damage the electronics of the cooling device.
For safety reasons the cooling device is equipped with an electronic system
to prevent the polarity reversal. This protects the cooling device against short-
circuiting when connecting to a battery.
➤ Plug the DC connection cable into the DC socket and connect it to a DC
power socket.
➤ Plug the AC connection cable into the AC voltage socket and connect it to
an AC mains.
➤ Close the covers of the sockets not in use to prevent accidentally touching
the sockets. This also prevents dust, water and dirt from entering the
socket.
6.4

Using the battery monitor

The cooling device is equipped with a multi-level battery monitor that protects
your vehicle battery against excessive discharging when the cooling device is
connected to the DC power supply.
If the cooling device is operated when the vehicle ignition is switched off, the
cooling device switches off automatically as soon as the supply voltage falls
below a set level. The cooling device will switch back on once the vehicle
battery has been recharged to the restart voltage level.
A
NOTICE! Danger of damage!
When switched off by the battery monitor, the vehicle battery will
no longer be fully charged. Avoid starting repeatedly or operating
current consumers without longer charging phases. Ensure that the
vehicle battery is recharged.
EN
Operation
13