Setting The Cutting Height; Operation; Starting And Stopping The Engine; Mowing - Grizzly BRM 56 BSA Traduction De La Notice D'utilisation Originale

UK

Setting the Cutting Height

The equipment has 10 positions for set-
ting the cutting heigh (25-80 mm):
1. Pull the lever (18) outwards and
push it to the desired position .
2. Push the lever back in.
The correct cutting height is around
30 – 45 mm for an ornamental lawn and
around 40 – 65 mm for a utility lawn.
Select a greater cutting height for
the first cut of the season.

Operation

Observe the noise protection and
local regulations.
Starting and Stopping the
Engine
Warning! Petrol is flammable.
Start the engine at least 3 m
away from the filling location.
Start the equipment on a sturdy,
level base, if possible not in long
grass. Ensure that the cutting tool
is touching neither objects nor the
ground.
Regularly check petrol and oil level
(see „Initial Operation") and refill in
due time.
Starting the Engine:
1. Set petrol lever (23) to position
.
2. Pull the safety catch (3) towards
the handle bar (1) and hold it.
3. Pull the starter cord (22), the
engine starts.
86
Stopping the Engine:
4. Release the safety catch (3),
the engine stops and the blade
is slowed

Mowing

1. Start the engine (see
2. Wheel drive:
On: Pull the drive catch (2)
towards the handle bar. The
mower moves forwards.
Off: Release the drive catch (2)
The equipment stops.
Set petrol lever (23) to position
for short breaks and to re-
duce noise.
The change in motor revolutions
via both positions
does not influence the speed of
the power wheels. They cannot be
regulated.

Working Instructions

• As far as possible, mow the lawn when
it is dry in order to protect the turf.
• Set the cutting height such that the
equipment is not overloaded.
• Run the equipment at walking speed
in lines that are as straight as pos-
sible. For uninterrupted mowing, the
lines should always overlap by a few
centimetres.
• Do not move backwards.
• On slopes, always work across the
slope.
• If the blade comes into contact with
a foreign body, switch off the engine
immediately. Wait until the blade is
stationary and check the equipment
for damage. Restart work only if the
equipment is undamaged.
).
+