Güde MP 120/5A 24 LT Mode D'emploi page 16

Structural group 8
Fig. 19
Structural group 9
Fig. 20
Structural group 10
Fig. 21
12.2 Safety Instructions for the First Putting in Operation
Caution: Never let the pump dry-run.
The user shall be held liable before third parties for operating the pump (basins, reservoirs etc.).
The pump should be used on connections with a stray current protection switch (FI switch)!
Before putting in use, a competent electrician should check that extension cables are available.
Connection to the mains via plugging.
Check the voltage. Technical data on the plate should conform with the mains voltage.
If the pump is used in ponds, fountains etc. or in reservoirs or basins, all the standards in effect in the countries of use should be
observed. .
Electric pumps for the outdoor use (e.g. ponds) shall be equipped with rubber-coated electric cable type H07RNF + H05RNF,
according to standards DIN 57282 or DIN 57245.
No people or animals should be/ be diving in the water to be pumped (pools, cellars etc.).
Temperature of the fluid to be pumped should not exceed +35° C. If extension cables are use they should be only of rubber type
H07RNF, according to standards DIN 57282 or DIN 57245. Never pull or hold the pump connected to the mains by the cable. Mind
that the socket should be kept away of water and moisture for the plug to be protected.
Before putting the pump in operation check the electric cable and/or the plug for damage. .
Unplug the pump before doing any work on it.
If the pump is built in a gully hole, the hole should be covered up after completion of the job in order to ensure the safety of
pedestrians.
The owner (user) should take appropriate safety measures (alarm installation, stand-by pump etc.) in order to prevent
damages (flooded space etc.) resulting from aggravated operations of the pump (faults or defects).
If the pump is found defective, the repair shall be done by an authorised servicing facility only. Only genuine spare parts should
be used.
Please note that according to effective standards, we shall not be held liable for any damage caused by our units if anything
indicated below applies:
Inappropriate repairs done by other than authorised servicing facilities
Required structural groups
Structural group 7
Required structural groups
Structural group 8
Required structural groups
Structural group 9
16
Delivery contained parts and
accessories
Fig. 11 – pos. 1
Fix the household water plant in
proper holes in the pump feet to
provide for its safe position.
Fill the pump via the filling neck until
clean water is running out. .