learning mode
specify end positions
8.3.3.
normal operation
Display normal operation
32
→
Press <OPEN> and <CLOSE> push-buttons and switch on the card
(hold down push-button).
The RED and the GREEN LEDs light up.
G
R
→
Release <OPEN> and <CLOSE> push-buttons.
Both LEDs go out.
Learning mode is selected.
→
Press <CLOSE> push-button to move the shut-off valve into the
closed position.
R
The RED LED lights up.
→
Press <MEM> and <CLOSE> push-buttons to save the closed
position.
R
The RED LED lights up 2x.
→
Press <OPEN> push-button to move the shut-off valve into the open
position.
G
The GREEN LED lights up.
→
Press <MEM> and <OPEN> push-buttons to save the open position.
R
The GREEN LED lights up 2x.
All positions are now saved.
→
Disconnect the card from the power supply.
→
Switch on card.
The GREEN LED lights up 3x to indicate that the start process has been
G
implemented correctly.
In normal operation the GREEN LED lights up when the rotary actuator
G
opens the shut-off valve.
The RED LED lights up when the rotary actuator closes the shut-off valve.
R
If neither of the LEDs is lit, the actuator is not actuated.
G
R
The RED and the GREEN LEDs light up if the torque is too high and the
rotary actuator stops.
G
R
→
Change direction of rotation of the rotary actuator or switch over the
voltage OPEN/CLOSED to restart the rotary actuator!
English
Type 3005
Installation