Burkert 3005 Mode D'emploi page 31

Type 3005
Installation
8.3.2. parameterization steps
specify direction of rotation of the shut-off valve
normal direction of rotation (preset)
G
reverse direction of rotation
R
specify control signal type
control signal when voltage 0 – 10 V
R
control signal when current 0 – 20 ma
R
control signal when current 4 – 20 ma (preset)
R
→
Press <OPEN> push-button and switch on the card (hold down
push-button).
The GREEN LED lights up.
→
Release <OPEN> push-button and disconnect the card from the power
supply.
→
Press <CLOSE> push-button and switch on the card (hold down
push-button).
The RED LED lights up.
→
Release <CLOSE> push-button and disconnect the card from the
power supply.
→
Press <MEM> push-button and switch on the card (hold down
push-button).
The RED LED lights up 3x.
→
Release <MEM> push-button and disconnect the card from the
power supply.
→
Press <MEM> and <OPEN> push-buttons and switch on the card
(hold down push-button).
The RED LED lights up 3x.
→
Release <MEM> and <OPEN> push-buttons and disconnect the
card from the power supply.
→
Press <MEM> and <CLOSE> push-buttons and switch on the card
(hold down push-button).
The RED LED lights up 3x.
→
Release <MEM> and <CLOSE> push-buttons and disconnect the
card from the power supply.
English
31