9.4.
installation of safety block into the actuator drive
Figure 29:
Illustration: installation of safety block into the actuator drive
→
Fasten the safety block of the emergency current model onto the actuator drive with 4
(see illustration "Figure 29").
→
Connect the battery in this order:
1. F+ (wire color red)
2. E-
(wire color black)
→
Connect the power supply in this order:
1. terminal 18
2. terminal 17
(see "Figure 28: Illustration: Electronic printed circuit board").
36
English
Type 3005
Option:Rotaryactuatorswith
emergencycurrentmodel
4 fastening screws ST2.2 x 6.5