Preparation; Care And Maintenance - Bresser BIOLUX NV Mode D'emploi

to the troubleshooting chapter that follows.
9.2.2. Installation of the Image Editing
Software Photomizer
The image editing software "Photomizer" is
located on the software CD. You can edit your
pictures here.
1. To install the software, click once on the
menu point "Install PHOTOMIZER" with the
left mouse button.
2. The Photomizer Software
Microsoft .NET Framework 4.0, which it
will install if it is not already on your system.
If it is already on your system, you may skip
to step 5.
3. In the welcome window, please accept
the Microsoft license agreement, and then
click "Install". The installation can take a
few minutes.
4. As soon as everything is installed, click
"Finish".
5. Now you will be presented with a choice,
in which you can choose your language.
Make your selection and confirm it by
clicking „OK".
6. When you see "Welcome", click on
„Next".
7. In the next window, you will be asked for
the „Destination Folder". Here, just click on
„Next".
8. Now, the window with the Setup-Status will
appear – here, a progress bar will inform
22
you about the ongoing installation. This
process can take a few minutes.
9. The window "Photomizer is being installed"
appears. Click on "Finish". The installation
ends.
TiP:
i
To use the MikrOkular long-
term we recommend it al-
ways be connected to the
same USB port.
requires
10. Using the MicrOcular

10.1. Preparation

1. Slide a specimen under your microscope
and focus on it.
2. Remove the eyepiece and Barlow lens
from the eyepiece support and the dust
cap from your MikrOkular and install same
in the eyepiece supports instead of the
Barlow lens.
3. Start your PC if you haven't yet and connect
your MikrOkular to the USB port of your
computer.
10.2. Showing and saving MikrOkular
images on your PC
1. Start the Photomizer Software.
2. Click „Open camera"
3. In the event that you have connected more
than one unit, you can choose the desired
unit in the subsequent selection. Click on
"USB 2.0 Webcam". If only one device is
connected, this step is omitted.
4. The camera image should now be visible on
your screen. Focus the microscope image.
5. Click „Capture" to record an image. It will
then be shown on the right.
6. Click on it to select it and then click
„Transfer image".
7. This takes you to the Photomizer software.
8. File - Save as
10.3. The Photomizer Software
If you need help in the „Photomizer" programme
click „?" and then „Open help". If you need
further assistance please visit the maker's
home page at www.photomizer.net/bresser

Care and maintenance

Separate the device from the power supply
before cleaning (remove batteries)!
Only use a dry cloth to clean the exterior of
the device.
nOTe:
Do not use any cleaning
fluid to avoid damaging the
electronics.