Software Installation; Driver Installation - Bresser BIOLUX NV Mode D'emploi

examination. They will move in the solution
using their hair like limbs. Remove a few daily
from the container for examination under
the microscope. If you do so and save the
pictures made with the MicrOcular you will
then have a seamless record of the prawn's
lifecycle. You can remove the upper lid of
the prawn bleeding plant and put the whole
thing under the microscope. The larvae will
mature in six to ten weeks depending on
ambient temperature. You will soon have bred
an entire generation of saltwater prawns that
constantly reproduce.
7.3.4. Feeding your saltwater prawns
To keep them alive saltwater prawns must be
fed occasionally. This must be done carefully
as overfeeding causes the water to stagnate
and poison the prawns. Feeding is best done
with dry powdered yeast (Fig 2, 25a). Give
them a little every other day. If the water
darkens this signifies it is stagnating. If so
remove the prawns and put them in a fresh
saline solution.
8. MicrOcular setup
nOTe:
The MicrOcular only works
without the Barlow lens sup-
plied. Magnification setting is
changed by using the MicrO-
cular and must be reset by
re-focussing.
Remove the Barlow lens (Fig 5, 3) and
eyepiece currently in use from the eyepiece
holder (Fig 5, 5) and replace them with
the MicrOcular (PC-Ocular) (Fig 6, 4) and
reducer lens (Fig 6, F) as in illustration 6 in
the holders (Fig 6, 5)
nOTe:
Please do not yet connect
MicrOcular and PC. Please
go through the items below in
sequence.
9. Installation and use of the software
9.1. Software and installation information
A software CD is included with your
microscope. The software and drivers on
this CD must be installed on your computer
in order to use your MicrOcular. Once you
connect the MicOcular to your computer after
installation, you can view pictures on and save
them to your computer using Photomizer. To
install the software and driver correctly, simply
follow the installation steps.

9.2. Software installation

1. important: Before inserting the CD, first
plug the USB cable into the USB port on
your PC. Windows will now recognize
the new device, and will indicate this in a
notification window. Now please click on
"Cancel".
2. Now insert the CD-ROM that came in your
package into the CD/DVD drive of your
computer. The installation menu starts
automatically. If it does not, go to the
Windows explorer and select the CD/DVD
drive (most of the time, it's the "D" drive, but
it can have another letter). From there, start
the file "autorun.exe" by double-clicking
with the left mouse button.

9.2.1. Driver installation

To install the driver software, click on the
menu point "Install Driver" with the mouse
cursor. Then follow the installation program
instructions. During the software installation
the correct driver for your operating system
will be installed automatically. No manual
input is needed. In rare cases the device
may not be recognised by your computer.
As a rule you need then only install the driver
manually from the CD. If this fails please refer
DE
GB
FR
NL
IT
ES
PT
FI
SE
SI
HU
SK
CZ
PL
RO
21