Preparation; Care And Maintenance - Bresser BIOLUX Advance Mode D'emploi

5. Now you will be presented with a choice,
in which you can choose your language.
Make your selection and confirm it by
clicking „OK".
6. When you see "Welcome", click on
„Next".
7. In the next window, you will be asked for
the „Destination Folder". Here, just click on
„Next".
8. Now, the window with the Setup Status will
appear – here, a progress bar will inform
you about the ongoing installation. This
process can take a few minutes.
9. The window "Photomizer is being installed"
appears. Click on "Finish". The installation
ends.
TiP:
i
To use the
camera long-term
recommend it always be
connected to the same USB
port.
9. Using the integrated camera

9.1 Preparation

1. Slide a specimen under your microscope
and focus on it.
2. Start your PC if you haven't yet and connect
The microscope to the USB port of your
computer.
9.2 Showing and saving images taken
with the microscope camera on your
PC
1. Start the Photomizer Software.
2. Click „Open camera"
3. In the event that you have connected more
than one unit, you can choose the desired
unit in the subsequent selection. Click on
"USB 2.0 Webcam". If only one device is
connected, this step is omitted.
4. The camera image should now be visible
on your screen. Focus the microscope
image.
5. Click „Capture" to record an image. It will
then be shown on the right.
6. Click on it to select it and then click
„Transfer image".
7. This takes you to the Photomizer software.
microscope
8. File - Save as
we
9.3 The Photomizer Software
If you need help in the „Photomizer" programme
click „?" and then „Open help". If you need
further assistance please visit the maker's
home page at www.photomizer.net/bresser

Care and maintenance

Separate the device from the power supply
before cleaning (remove batteries)!
Only use a dry cloth to clean the exterior of
the device.
nOTe:
Do not use any cleaning
fluid to avoid damaging the
electronics.
Clean the lenses (eyepiece and/or lens) with a
soft and lint-free cloth only (e.g. microfibre).
nOTe:
Do not apply excess pressure
to the cloth so as to avoid
scratching the lenses.
To remove more stubborn dirt, moisten the
cleaning cloth with an eyeglass-cleaning
solution and wipe the lenses gently.
Protect the device from dust and moisture.
Store it in the supplied bag or transportation
packaging. The batteries should be removed
from the unit if it has not been used for a long
time.
DE
GB
FR
ES
21