Programming Of The Speed Controller; Readjusting The Rear Spoiler - df models DRIVE&FLY Brushless Speedfighter-X 4WD RC Buggy 1/8 Notice D'utilisation

. Programming of the speed controller

The speed controller is already adjusted to the remote control unit included and the model. When using a new speed control-
ler or a new transmitter and after reversing the direction of the rotation of the motor by means of the reverse switch on the
transmitter, however, the control range of the accelerator/brake lever has to be reset.
Setting the control range of the accelerator/brake lever
> Switch the speed controller off and the transmitter on.
> Undo the cotter pins and open the receiver/controller box.
> Press and hold down the set button (arrow) and switch on the speed controller.
As soon as the red LED begins to blink, immediately release the set button.
> Put the accelerator/brake lever in the neutral position and press the set button.
The green LED will blink once, and a signal sound will be heard.
> Put the accelerator/brake lever in the full speed position and press the set button
another time.
The green LED will blink twice, and the signal sound will also be heard twice.
> Put the accelerator/brake lever in the braked position and press the set button
another time.
The green LED will blink three times, and the signal sound will also be heard
three times.
> The adjustment of the control range is now completed, and the motor can be started after 3 more seconds.
For more far-reaching programming, follow the separate Operating Instructions for the speed controller.
The speed controller has more adjustments for advanced drivers, such as:
> 3 operating modes "forward with brake", "forward/reverse with brake" and "rock crawler mode" (forward/reverse, without
brake)
> 8-stage "drag brake" setting
> 6-stage selection of the interrupting voltage
> 9-stage adjustment of the start-up behaviour ("punch") from "soft" to "very aggressive"
> 4-stage setting of the maximum braking strength
> 4 reverse speeds
> 4-stage setting of the braking strength when the braking takes affect
> 3-stage neutral operation
> 8-stage motor timing (only with sensorless motors)
Furthermore, an external module, a programming card, is available in the accessories for user-friendly programming of the
speed controller.

. Readjusting the rear spoiler

Besides the set up of the chassis, the handling can also be influenced by readjusting
the rear spoiler.
Setting the rear spoiler at a steep angle provides for downthrust and thus for grea-
ter attraction on the rear axle at low speeds, and a more level position provides for
downthrust at higher speeds.
The angle of the rear spoiler can be set to be more steep or more level by and doing
the mounting device and readjusting it in a different fastening point.
- 0 -
3211/V1/0110