Led Displays And Alarms During Operation - df models DRIVE&FLY Brushless Speedfighter-X 4WD RC Buggy 1/8 Notice D'utilisation

1� Put the accelerator/brake lever into the neutral setting now
and press the set button again. The green LED will blink once
and a signal sound will be heard (1 time).
2� Put the accelerator/brake lever in the full speed position and
press the set button another time. The green LED will blink twi-
ce, and the signal sound will also be heard twice.
3� Put the accelerator/brake lever in the brake position and press
the set button again. The green LED will blink three times, and
the signal sound will also be heard three times.
The adjustment of the control range is now completed, and the motor can be started after 3
more seconds.
If you press the set button too long after the red LED has started blinking, the green
LED will blink and the controller has entered the programming mode. In this case,
switch the controller back off and start the adjustment again (steps 1-3).
6. lEd
displays and alarms during opEration
The signal sounds will be heard only if the motor is connected to the speed
controller!
> As long as the accelerator/brake lever is in the neutral setting, neither the red nor the green
LED will blink.
> The red LED blinks during forward and reverse drive.
> The red LED blinks when the model is braked.
> The green LED blinks if the accelerator/brake lever is at the front or rear end point.
> Two signal sounds in quick succession, with repetitions at 1 second intervals indicate that the
input voltage is too low.
> Individual signal sounds at intervals of 2 seconds indicate a missing input signal.
> The automatic cell number detection is activated in the basic setting when the speed control-
ler is turned on. Each detected cell triggers a signal sound.
Check whether the number of cells has been determined correctly!
If you are using LiPo batteries then you must enter the number of actually used LiPo
cells manually in programming step 12!
-  -