Grillo FX27 ZERO TURNING Manuel D'utilisation page 16

FX27 / Translation of the original instructions
TOWING THE MACHINE WHEN THE ENGINE IS CUT OFF
Attention! To be able to move the machine when the engine is cut off use the hydrostatic transmissions
by-pass levers (fig. 5, ref.C); pay attention because doing so the efficiency of the self-sustaining braking
system is cancelled. Tow the machine at a very low speed (less than 3.2 km/h) and only over short
distances, no longer than 100 metres, to avoid seizing of the hydraulic pump or of the engines
inside the hydrostatic unit.
STORAGE AND LACK OF USE FOR LONG PERIODS
Store the machine in a dry environment, sheltered from bad weather and, if possible, covered up. If the
mower will not be used for a long period (more than one month), disconnect the battery red cable and
follow the directions given in the engine manual; in addition grease all the joints. Check regularly that the
battery voltage has not dropped below 12.5 Volts and if necessary, recharge it.
WARNINGS FOR TRANSPORT
In case it should be necessary to lift the machine, check the machine's weight on the identification plate
and use only suitable equipment (ramps, cranes, etc.). If the machine is carried with a lorry or with a
towed trailer, set the cutting deck at a low position, apply the parking brake and tie the machine up to the
means of transport using ropes, cables, or chains.
15