6.5.3.2 Fixing with corner adapter
To fix the wall support bracket to the corner adaptor
module, use the 4 flat washers, the 4 grower washers
in stainless steel and the 4 hexagonal head screws in
stainless steel (A4 class 70) M10x30mm supplied.
Make sure the thread are free of dirt and debris.
Apply a generous amount of threadlocker (Loctite
270) on the 4 threaded holes on the corner module.
Tighten the screws.
Pay attention to the fixing. Tightening
torque: 35Nm.
The thread compound must cure for one hour, allow
for this period prior to completing the installation.
Fig. 11
MNVCNXPTZ2_2032_EN
6.5.4 Sunshield mounting
You can fix the sunshield to the housing using the
screws supplied.
Apply a generous amount of thread locking
compound (Loctite 270) into the threaded holes in
the base of the device.
Pay attention to the fixing. Tightening
torque: 2Nm.
The thread compound must cure for one hour, allow
for this period prior to completing the installation.
Fig. 12
17