Switching On; First Start-Up; Configuration; Default Ip Address - Videotec Série 2 Manuel D'instructions

8 Switching on

The automatic pre-heating (De-Ice) process
could be started whenever the device is
switched on and the ambient temperature
is below 0°C (+32°F). The procedure is
necessary to guarantee correct operation
of the devices even at low temperatures.
The duration ranges depending on
environmental conditions (from 60 minutes
up to 120 minutes).
The unit is switched on by connecting the power
supply.
To switch off the unit disconnect the power.

8.1 First start-up

Make sure that the unit and other
components of the installation are closed
so that it is impossible to come into contact
with live parts.
Make sure that all parts are fastened down
firmly and safely.
MNVCNXPTZ2_2032_EN

9 Configuration

9.1 Default IP address

The unit is configured to obtain an IP
address from a DHCP server.
The IP address acquired via DHCP is visible in the
DHCP server log file.
If the DHCP server is not available, the unit
automatically configures itself with a self-generated
IP address in the 169.254.x.x/16 subnet. Configuring
the IP address of the PC as belonging to the same
subnet (example: IP address: 169.254.1.1, subnet
mask: 255.255.0.0).
Use an ONVIF compliant VMS or a network sniffer to
find the IP address of the device (IP scan utility).

9.2 Web interface

Browsers supported (the latest version):
Microsoft Edge, Google Chrome, Mozilla
Firefox.
9.2.1 First access to the web pages
The first operation in configuring the device consists
in connecting to the web interface.
To access the web interface of the product, simply
use a browser to connect to http://ip_address.
On first access, the Home page will be displayed.
To configure the web interface, consult the manual
relating to the firmware version installed, available on
the product web page of the website www.videotec.
com.
21