Videotec Série 2 Manuel D'instructions page 11

• Equipment intended for installation in Restricted
Access Location performed by specialist technical
staff.
• To comply with the main supply voltage dips and
short interruption requirements, use a suitable
Uninterruptable Power Supply (UPS) to power the
unit.
• The safety earthing system must be carried out
according to local installation dispositions.
• The separate protective earthing terminal provided
on this product shall be permanently connected
to earth.
• For continued protection against risk of fire,
replace only with same type and rating of fuse.
Fuses must be replaced only by service personnel.
• Connect the device to a power source
corresponding to the indications given on the
marking label. Before proceeding with installation
make sure that the power line is properly isolated.
The supply voltage should never exceed the limit
(±10%).
• The appliance includes moving parts. Make sure
that the unit is positioned where it is inaccessible
under normal operating conditions. Attach the
warning label supplied with the appliance, placing
it near the unit so that it can be seen easily.
MNVCNXPTZ2_2032_EN
• Attach the Dangerous Moving Parts label near the
device. (Fig. 5, page 14).
• Do not use the appliance in the presence of
inflammable substances.
• Only skilled personnel should carry out
maintenance on the device. When carrying out
maintenance, the operator is exposed to the risk of
electrocution and other hazards.
• Use only the accessories indicated by the
manufacturer. Any change that is not expressly
approved by the manufacturer will invalidate the
guarantee.
• Before connecting all the cables make sure the
device is properly connected to the earth circuit.
• If the device has to be removed from the
installation, always disconnect the earth cable last.
• Take all necessary precautions to prevent the
apparatus from being damaged by electrostatic
discharge.
• Handle the unit with great care, high mechanical
stress could damage it.
• Make especially sure that the power supply line is
insulated at a sufficient distance from all the other
cables, including lightning protection devices.
9