MDR .. EC
5. With
values (S1/S2).
6. If necessary, make settings for the 2nd set
point (steps 2 to 4).
7. To exit the settings menu, press the key
combination
press
13.4 Commissioning
Procedure
1. The unit must be mounted and connected
according to the operating instructions.
2. All connections must be checked again for
correctness.
3. The supply voltage must correspond to the
specifications on the rating plate.
4. In BASE SETUP, adjust the sensor (autozero)
(
Chapter 13.5).
5. For operating mode 4.01 under SETTING
set the parameters for temperature-con-
trolled operation.
FIG
/
change between the setting
back to the start display.
DE
+
= Esc and then
UK
VENTILATOREN
FR