Leds On Battery; Led On Charger; Assembling The Saw; Mounting And Removing The Bar And Chain - Stihl MSA 120 C, MSA 140 C Notice D'emploi

English
► If the LED on the right flashes green: Charge the battery.
6.4

LEDs on Battery

The LEDs can show the state of charge or malfunctions. The
LEDs can glow or flash green or red.
The state of charge is indicated when the LEDs glow or flash
green.
► If the LEDs glow or flash red: Troubleshooting, @ 19.
Malfunction in chainsaw or battery.
6.5

LED on Charger

The LED indicates the operating status of the charger.
If the LED glows green, the battery is being charged.
► If the LED flashes red: Rectify the malfunction.
Malfunction in charger.

7 Assembling the Saw

7.1

Mounting and Removing the Bar and Chain

7.1.1 Mounting the Bar and Chain
The bar and chain combinations that can be used with the
chain sprocket are listed in the specifications, @ 21.
► Switch off the chain saw, engage the chain brake and
remove the battery.
1
3
70
► Raise the grip (1) of the wingnut (2).
► Rotate the wingnut (2) counterclockwise until the chain
► Remove the chain sprocket cover (3).
► Remove the tensioning gear (4).
► Take out the screw (5).
► Place the guide bar (6) on the tensioning gear (4) so that
The guide bar (6) may be either way round. The logo on the
guide bar may also be upside down.
► Insert and tighten down the screw (5).
2
► Fit the chain in the bar groove so that the arrows on the tie
► Turn the tensioning gear (4) clockwise as far as stop.
sprocket cover (3) can be removed.
5
4
both pegs on the tensioning gear (4) engage the holes in
the guide bar.
4
straps on top of the bar point in the direction of rotation.
7 Assembling the Saw
6
5
4
0458-716-9621-C